Nor-lake Stability Chambers Manual de usuario

STABILITY CHAMBERS Installation, Operation and Maintenance Instructions GENERAL 2 Inspection 2 Location 2 Installation 2 Door Alignment 2

GENERAL INSPECTION When the equipment is received, all items should be carefully checked against the bill of lading to insure all crates and cartons

Duplex/ or European Outlet - (Optional) is located near the top of the interior cabinet back. This is a 15 amp 115 volt duplex PN 88010300 with its o

An 18” length of 1/2" I.D. drain hose is shipped inside cabinet. Attach hose to drain stub under cabinet with supplied clamp and run to an atmo

- 5 - The cabinets utilize electrically operated heaters to warm the cabinets in the heating mode. The heating elements are located in the interi

CLEANING THE HUMIDIFIER Before Cleaning: 1. Disconnect the electrical plug from power source. Turn off water supply. (See Figure D) 2. Unfasten th

- 7 - 4. Clean the Atomizing Unit. Do not submerge in water. a. Slightly twist the Cylindrical Screen out of the lock position and remove. b.

- 8 - MALFUNCTION POSSIBLE CAUSE SOLUTION Compressor will not start - 1. Service cord unplugged 1. Plug in service cord no hum 2. Fuse bl