Nor-lake AdvantEDGE Back Bar Refrigeration Manual de usuario descargar pdf

09/13 Rev.G 143594

BACK BAR REFRIGERATION

Installation, Operation and Maintenance Instructions

INSPECTION

When the equipment is received, all items should be carefully checked against the Bill

of Lading to ensure all crates and cartons have been received. Do not sign the freight

bill clear until the freight has been properly inspected for damage. All units should be

inspected for damage including concealed damage by uncrating immediately. If any

damage is found, it should be reported to the carrier at once, noted on the Bill of Lading

and a claim should be filed with the carrier. This equipment has been inspected and

tested in the manufacturing facility and has been crated in accordance with

transportation rules and guidelines. The manufacturer is not responsible for freight loss

or damages.

INSTALLATION

After removing the unit from the packaging, clean the interior and exterior surfaces of

the unit with soap and water and a rinse with clean water. Do not use chlorinated

cleaners on the surfaces as they can cause corrosion.

This unit is designed for indoor use only. Be sure to locate the unit where the floor can

support the weight of the unit and product installed inside of it. The refrigeration system

located at the bottom left of the unit requires free air access for proper operation. Allow

a minimum of two inches between the back of the cabinet and the wall. Do not locate

the unit next to heat generating equipment or in direct sunlight.

Confirm that the proposed electrical outlet has the correct voltage, frequency and

current carrying capacity for the requirements of the unit. This information is noted on

the data plate on the inside left wall of the unit. The unit should be isolated on a circuit.

Do not use an extension cord to get power to the unit. Improper electrical installations

will void the compressor warranty. To prevent shock and fire, be sure the unit is properly

grounded.

Local health codes may require that the unit be sealed to the floor with an NSF

approved silicone sealant if it is not on legs or casters. After the unit is set in its desired

location, simply apply a bead of sealant around the base of the unit and smooth it out.

The shelves and shelf support clips are shipped inside the cabinet. Install the shelf

support clips on the pilasters mounted on the inside walls of the cabinet and set the

shelves on the supports. The shelves are adjustable in ½” increments to suit your

needs.

1 2 3 4 5 6

Indice de contenidos

Pagina 1 - BACK BAR REFRIGERATION

09/13 Rev.G 143594 1 BACK BAR REFRIGERATION Installation, Operation and Maintenance Instructions INSPECTION When the equipment is received, all

Pagina 2 - OPERATION AND MAINTENANCE

09/13 Rev.G 143594 2 OPERATION AND MAINTENANCE This cooler is designed to maintain your product temperature within the most desirable range of +34°

Pagina 3 - SPECIFICATIONS*

09/13 Rev.G 143594 3 TROUBLESHOOTING Problem Remedy Compressor will not start · Check the power cord and make sure it is plugged in and has power.

Pagina 4 - 09/13 Rev.G 143594

09/13 Rev.G 143594 4 BB SERIES REPLACEMENT PARTS LISTS Item Number Part NumberDescriptionBB59BB69 BB79 BB951 150315Compressor 115vXX XX2 150316Comp

Pagina 5

09/13 Rev.G 143594 5

Pagina 6

09/13 Rev.G 143594 6

Comentarios a estos manuales

Sin comentarios

Nor-lake AdvantEDGE Back Bar Refrigeration Manual de usuario

Busca en linea o descarga Manual de usuario para Refrigeradores Nor-lake AdvantEDGE Back Bar Refrigeration. Nor-Lake AdvantEDGE Back Bar Refrigeration User Manual Manual de usuario

Indice de contenidos

Comentarios a estos manuales

Relacionado con productos y manuales para Refrigeradores Nor-lake AdvantEDGE Back Bar Refrigeration